Top Patio Loveseat

Look For In a Patio Loveseat Ideas

Top Large Patio Umbrellas

Stylish Large Patio Umbrellas

December 4, 2019 Patio Ornaments

Building a Patio Chaise Lounge Chair

Patio chaise lounge – These chairs can be expensive to purchase, and some of the cheapest are not only comfortable. You get a sense of pride and accomplishment by building your own and you can save some money, too. This can be done with the right tools, materials and some guidance. Tools and Materials for patio chaise lounge; you’ll need some power tools and knowledge of how to use them. A table saw, drill and bits and router are power tools you need. Other tools include a tape, sandpaper, paper and pencil, hammer and nails, screws, dowels and stain or paint.

Best Patio Chaise Lounge

Best Patio Chaise Lounge

The base of the patio chaise lounge chair requires two 2 by 4 boards, which measure about a half-foot long. Use the tape measure and pencil to measure accurately and cut these lengths. For the back frame, measure and cut two tables of 2 by 4 about 4 inches long. Although the pieces that run along the back of the chair normally be 6 inches long, these are adjustable if you want a wider deck chair and can be cut a little longer. It is easier to sand and paint or stain these pieces before the construction of the living room.

12 Inspiration Gallery from Building a Patio Chaise Lounge Chair

Image of: Best Patio Chaise Lounge
Image of: Classic Patio Chaise Lounge
Image of: Patio Chaise Lounge Design
Image of: Patio Chaise Lounge Furniture
Image of: Patio Chaise Lounge Ideas
Image of: Patio Chaise Lounge Image
Image of: Patio Chaise Lounge Photo
Image of: Rustic Patio Chaise Lounge
Image of: Simple Patio Chaise Lounge
Image of: Stylish Patio Chaise Lounge
Image of: Wicker Patio Chaise Lounge
Image of: Amazing Patio Chaise Lounge
 
READ ALSO :   Homemade Patio Umbrella Stand Ideas

The pieces of pins must be the same length as the timber is placed on the back of the patio chaise lounge chair. After about 4 inches, it is added to the width to match the plates 2-by-4. Wood 1-for-2 is used for backup and measured accordingly. The seat requires wood 1-for-3, and the same procedure is used with these boards.

Comments are closed.